| TS4/300
round electrodes: |
TS12/300
round electrodes: |
Very
thin insertion electrodes (uninsulated, 0.2 mm, Diameter 2 mm,
Length 200 mm or 300 mm) for moisture measurement in building
and insulating materials through joints or cross joints.
#TS4200 or #TS4300 $7800 FOB CA |
Insulated
electrodes (0.4 mm, Diameter 4 mm, Length 200 mm or 300 mm)
for specific moisture measurement in concealed component
levels where the electrode shaft needs to be insulated.
Absence of insulation would falsify the measuring result. The
most frequent use is the determination of moisture
distribution of multilayered wall or ceiling structures such
as floating screeds, multilayered walls, wooden beam ceilings,
hot roofs etc.
#TS12200 or #TS12300 $9500 FOB CA |
| TS16/300
flat electrodes: |
TS20/110
brush electrode: |
The
advantage of the flat electrodes (1 mm flat, 200 mm or 300 mm
Length) is that there are no holes in the surface and the
electrodes can be inserted through the edging strip after
removing the base.
#TS16200 or TS16300 $9500 FOB CA |
With
110 mm long brush head (Diameter 7 mm) and insulated shaft.
The area of application is the specific measurement of
moisture in a homogeneous building material without using a
contact mass (the brushes will give a better coupling even in
porous materials). The connection to the goods to be measured
is made by the brush head.
#TS20110 $6000 FOB CA |
| TS50
insertion electrodes: |
Layer
depth electrodes TS 24/250: |
The
two-part insertion electrode TS50 enables the variable
distance when positioning the electrode pins. The area of
application is the measurement of moisture in hard building
materials such as concrete or screeds.
#TS050 $4300 FOB CA |
The
area of application is the specific layer moisture measurement
in homogeneous building materials using the contact mass. The
material humidity can be determined according to the length up
to a maximum depth of approx. 250 mm (Diameter 8 mm).
#TS24250 $13000 FOB CA |
| TS60
hand electrode: |
TS70
hammer electrode: |
Unbreakable
plastic handle with two hexagon union nuts in which electrode
pins can be inserted. Areas of application are measurement of
moisture in cut timber or wooden board materials (e.g.
chipboard or fibre boards) and measurement of moisture in soft
building materials such as plaster or roughcast mortar.
#TS060 $6000 FOB CA |
With
moving hammer handle for precision zone and depth measurement
especially in woods with different moisture distribution, e.g.
liquid nests using tefloncoated electrode pins. These are
available in lengths of 45 and 60 mm.
#TS070 $13500 |
