Amprobe AT-7000-T AT-7000 Advanced Wire Tracing Transmitter with LCD

The Amprobe AT-7000-T features three power modes “high,” “low,” and “clamp” and two output frequencies (6 kHz and 33 kHz). The AT-7000-T incorporates the best technologies available for optimal wire tracing and breaker identification on both energized and de-energized circuits. The AT-7000-T automatically sets the frequency based on detected voltage, and prompts the user to set the power level based on their application. The color TFT LCD screen displays the detected voltage, frequency output and power mode.

When there’s no access to bare conductors, use the SC-7000 signal clamp to induce a signal into either energized or de-energized circuits for wire tracing and load locating. The AT-7000-T transmitter’s “clamp” mode provides a boosted 6 kHz signal through the clamp to further improve accuracy and performance.

The AT-7000-T Transmitter works on energized and de-energized circuits up to 600V AC/DC in Category I-IV electrical environments.

The transmitter will measure the line voltage and display it on the transmitter’s color TFT LCD display screen. Based on detected voltage it will automatically switch to either energized mode (30 to 600V AC/DC) or de-energized mode (0 to 30V AC/DC). The energized mode uses a lower transmission frequency (6kHz) than de-energized mode (33 kHz) to reduce signal coupling with nearby metallic objects and improve results. If the circuit is energized the red LED in the upper left corner of the AT-7000-T transmitter will light.